Work Pro W DUO DIM Manual De Uso página 8

2. Operation Guide
Circuit A or B Enable
DMX
Circuit A
CircuitB
MENU
DMX Address Setting
DMX
Circuit A
CircuitB
MENU
NOTE: If the LED display shows "A" following three numbers, it indicates
the selection of Circuit A, "b" following three numbers for Circuit B.
Dimmer/Switch Pack Enable
DMX
Circuit A
CircuitB
MENU
NOTE: The LINEAR output enables in the Dimmer Pack Mode and the Non_Dim
output enables in the Switch Pack Mode.
DMX
Circuit A
CircuitB
MENU
DUO DIM
When the power is turned on, this unit enters Circuit A or B
selection mode automatically, and the LED display shows
"C" followed by "A" or "b".
Press the Up/Down button for selecting the desired circuit
to set, a constant light of the desired circuit LED in the
Segment Display indicates its selection.
This function allows you to separately set DMX address for
Circuit A or Circuit B.
1. DMX address setting mode enables.
2. The LED display shows "A" or "b" followed by three
numbers(001-512). Use the Up/Down button to select your
desired DMX address.
This function allows you to separately set the output curve of
the unit as one Dimmer Pack or Switch pack.
1. Dimmer/Switch mode enables.
2. The LED display shows "D---" or "S---". Use the Up/Down
button to change between the Dimmer Pack or the Switch
Pack.
3. When the LED display shows "D---", press the MENU
button to enter the DMX Limit function.
User Manual/Manual de uso Pag. 7