Accessmatic Infinity 624 Manual De Usuario página 45

Infinity
624
Troubleshooting
The Blue LED is NOT Blinking when
pairing
Blue and Green LED blinks alternati-
vely when Connecting to Accessmatic
by the rst user
RED blinks when Connecting to
Accessmatic by the rst user
RED LED blinks when Enter the PIN
code
Green LED is blinking
RED LED ON
How should I change my PIN code
Return to the factory setting
Figure 33
Fault appearance
Press the (R) button of the AccessAgent
Entering a wrong password to your Wi network
The AccessAgent cannot get a IP from the router. Please
disconnect other device
Entering the wrong PIN code. Please check with the rst
user
Wi signal is weak. Please adjust the antenna of the
AccessAgent or adding an Wi ampli er to
enhance to Wi signal
RED LED ON indicates a system error. Please Return to the
factory setting as mentioned below
Enter the operation page of the device in Accessmatic->
Click the (Device information) in the setting page -> Tap
(PIN Code Setting)
Return to the factory setting is used when you lose your
PIN code for sharing the device. After return to the factory
setting, please follow the previous indications to
reconnect the Accessmatic
Figure 34
Solution
Opening your life
Figure 35
21