Silver Eagle SE1100 Manual De Instrucciones página 4

MAINTENANCE
cauTion : Always be sure that the tool is switched off and
unplugged before attempting to perform.
Inspection and maintenance:
1. The brushes should be checked periodically and worn out brushes
should be replaced.
2. Keep the vent passage clear from dirt. Clean off the accumulated
dust and oil dirt periodically.
3. During normal operation, if any malfunction occurs, power supply
should be cut off at once and the tool should be checked and
repaired.
WARRANTY
Silver Eagle™ by Matco warrants this tool for a period of 1 year from original purchase. We will repair any SE1100 covered under this warranty which
proves to be defective in material or workmanship during the warranty period. In order to have your tool repaired, return the tool to Tri-County Power
Tool, Inc. or Pneutool Parts & Services Co. Ltd. at the address listed below, freight prepaid.
Please include your name and address, evidence of the purchase date, and description of the suspected defect. The tool will be inspected and if any part
or parts are found to be defective in material or workmanship, the tool will be repaired free of charge and returned to you freight prepaid. This warranty
does not cover damage to equipment or tools arising from alteration, abuse, misuse, damage and does not cover any repairs or replacement made by
anyone other than Matco,
Tri-County Power Tool, Inc. or Pneutool Parts & Services Co. Ltd. The foregoing obligation is Matco's sole liability under this or any implied warranty and
under no circumstances shall we be liable for any incidental or consequential damages.
Note: Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to
you.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
TRI-COUNTY POWER TOOL, INC.
Cleveland, OH 44109
(866) 873-8278 (toll-free)
(216) 398-6121 (fax)
SE1100
SE1100 7" Electric Polisher
4597 Pearl Rd.
(216) 398-6120
Replacing carbon brushes:
Remove and check the carbon brushes regularly. Replace when they
wear down to the limit mark. Keep the carbon brushes clean and free
to slip in the holders. Both carbon brushes should be replaced at the
same time. Use only recommended carbon brushes as listed on Pg. 5
of this manual.
cauTion: Only a qualified technician may repair the tool.
PNEUTOOL PARTS & SERVICES CO. LTD.
33 Haas Road
Toronto
ON M9W 3A1 Canada
(416) 748-1200
(888) 748-1201 (toll-free in Canada)
(416) 748-2695 (fax)
4 09/22/08