Descargar Imprimir esta página

Hilti TE 30-A36 Manual De Instrucciones página 16

Ocultar thumbs Ver también para TE 30-A36:

Publicidad

Idiomas disponibles

Idiomas disponibles

Observe the safety instructions and warnings in this documentation and on
the product.
5.1.1 Inserting the battery
1. Push the battery into the battery holder until it engages with an audible
click.
2. Check that the battery is seated securely.
5.1.2 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.1.3 Charging the battery
Make sure that the outer surfaces of the battery are clean and dry before
inserting the battery in the approved battery charger.
Read the operating instructions for the charger for further information
about the charging process.
▶ Use an approved charger to charge the battery.
5.1.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove in the product.
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the tool holder from the front
and into the recess provided.
3. Set the side handle to the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.1.5 Adjusting the depth gauge (optional)
1. Press the release button on the side handle.
2. Adjust the depth gauge to the desired drilling depth.
3. Release the release button.
4. Check that the side handle is securely attached.
5.1.6 Removing the chuck
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the
operator.
▶ Remove the depth gauge from the product.
10
English
2
3
4
5
6
2173713
*2173713*

Publicidad

loading