Dynamic Dynamix 160 Manual De Instrucciones página 10

User guide - Dynamix
MAINTENANCE
EN
It is preferable to regularly check:
- That the power cable is in good condi-
tion (the copper wires in the cable
should not be visible).
- That the tube is watertight (by visual-
ly inspecting the seal condition after
having removed the blades).
- That the blades are sharp. Replace the
blade if necessary.
If the power cable is damaged, it must be
replaced by the manufacturer, its after-
selfs service or people of similar qualifica-
tion to avoid danger.
ELECTRIC REQUIREMENTS
The mixer of a class 2 category (double
insulation) powered by a single phase
alternating current and does not require a
"u" ground plug.
The installation must be protected by a
ground fault circuit breaker and a 10 A
calibre fuse.
Use a standard 10/16 A single phased
socket.
Check that the electricity supply voltage
and the value on the charger specifications
plate are compatible.
10
V2
ELECTRICAL DIAGRAM
V1
L
V2
N
CERTIFICATE OF CONFORMITY
CUSTOMER SERVICE AND
WARRANTY
This machine is in accordance with CE
standards and :
• Customer service and warranty:
Should your unit require service, contact
your distributor for the nearest authorized
service centre if you wish your unit to be
serviced by the manufacture ship it to :
CANADA SERVICE CENTRE DYNAMIC
INTERNATIONAL LTD.
3227 Boul. pitfield
Saint-Laurent - Québec H4S-1H3
Toll free phone : 1-800-267-7794
Toll free fax : 1-877- 668-6623
Local Phone : (514) 956 0127
Local Fax : (514) 956 8983