Publicidad
Idiomas disponibles
Idiomas disponibles
English
Power/Level
1
2
3
100
300
400
500
Left front
(1000 W
(1000 W
(1000 W
(1000 W
on/off)
on/off)
on/off)
on/off)
100
300
400
500
Left rear
(1000 W
(1000 W
(1000 W
(1000 W
on/off)
on/off)
on/off)
on/off)
100
300
400
500
Right rear
(1000 W
(1000 W
(1000 W
(1000 W
on/off)
on/off)
on/off)
on/off)
100
300
400
500
Right front
(1000 W
(1000 W
(1000 W
(1000 W
on/off)
on/off)
on/off)
on/off)
200
400
600
1000
Right Bridge
(1400 W
(1400 W
(1400 W
(1400 W
on/off)
on/off)
on/off)
on/off)
200
400
600
1000
Left Bridge
(1400 W
(1400 W
(1400 W
(1400 W
on/off)
on/off)
on/off)
on/off)
Note:
Zone 1 and 2 (left front and rear) are using the sharing power electric, the max. power is 3500 W
Zone 3 and 4 (right rear and front) are using the sharing power electric, the max. power is 3500 W
Power off
To power of the cooking zone or co-
oktop use one of the following proce-
dures:
A. Press the desired cooking zone se-
lection key (12, or 14, or 18, or 20), the
digital display shows the set power,
press "-" key (15) until the display
shows "
", then press "-" (15) again and
1
the desired element will shut off.
B. Press the desired cooking zone se-
lection key (12, or 14, or 18, or 20),
press "-" key (15) hold for 3 seconds,
and the hob will shut off.
C. Press the "ON/OFF" key (6), it will
make a "beep" sound once, and it will
turn off all the active cooking zones.
14
INDULAP001
User Manual
4
5
6
7
8
800
1000
1300
1500
(1000 W
on/off)
800
1000
1200
1400
(1000 W
on/off)
800
1000
1300
1500
(1000 W
on/off)
800
1000
1200
1400
(1000 W
on/off)
1400
1700
2000
2300
1400
1700
2000
2300
The hob is now on standby mode.
The hob features an automatic shut off
feature that turns off the entire hob if
any cooking zone has been active conti-
nuously for 2 hours.
Power level selection
In order to adjust the
heating power,
press the "+" (17) or "-" (15) key. The
power adjusting range is as follows:
In heating state, the induction cooker
has the over-temperature protection
function. When the temperature of the
cooker is close to the set value, there
will be intermittent heating.
Timer function setting
Timer setting range is 1 to 99 minutes.
In cooking state, press the "timing" key
(16), the corresponding burner timing
User Manual
light (A, B, C, D), and the timing display
9
(3) will flash to show "
2000
press the fire control "-" (15) or "+" (17)
keys to adjust the timer time, which will
be increased or decreased in unit of 1
1600
minute if it is less than 15 minutes; in
unit of 5 minutes if it is between 15 mi-
2000
nutes and 40 minutes; or in unit of 10
minutes if it is between 40 minutes and
1600
99 minutes; After the keystroke opera-
tion is stopped, the timing display fla-
shes for 5 seconds, then it turns to nor-
2800
mal, the timing light flashes, and the
time countdown starts. When the timer
2800
countdown is finished, the induction
cooker rings "beep" and it will shut
down automatically. Note: after setting
the timer of each burner, the timer di-
splay will show the minimum time set.
Check timer
When timer is in function, press the
"timer" key (16), the corresponding
burner timer light (A, B, C, D) will be
on, and the timer display will flash to
display the current time.
Cancel timer function
When timer is in function, press the "ti-
mer" key (16), the corresponding bur-
ner timer light will be on, and the timer
display will flash to display the current
time; press the fire control "-" (15) key
to adjust the timer to "
mer display will flash for 5 seconds and
then go out, and the timer function will
be cancelled.
Note
". At this time,
A. After the induction cooker is shut
00
down, the fan will automatically delay
operation for 4 minutes to dissipate
heat.
B. When the centre temperature of the
Lapitec plate detected by NTC is higher
than 50 °C, the corresponding display
will show "
".
H
C. When the used cooker is inconsi-
stent or the cooker is moved away from
the induction cooker, the heating will
stop, the power display (2, or 4, or 9,
or 10) will show "
splay (3) will show "
cooker is not put in within 10 seconds,
it will automatically shut down.
D. In order to ensure the effect of co-
oking, please use the special cooker for
this kind of induction cooker to cook.
E. When the induction cooker is used
and the voltage is too high (or too low),
the heating will stop, the power display
(2, or 4, or 9, or 10) will show "
the timing display (3) will show "
"
"). If the voltage does not return to
E2
normal within 10 s, it will automatically
shut down. At this time, the induction
cooker will send out a warning beep,
", and the ti-
please turn off the power supply of the
00
induction cooker.
INDULAP001
English
", and the timing di-
E
". If the suitable
E1
", and
E
" (or
E3
15
Publicidad
