INVENTOR EP-BG62 Manual Del Propietário página 8

Use:
1. Connect the power cord to a power source, then press the
ON/OFF button located on the vacuum cleaner, to initiate
operation.
2. Suction can be controlled from the unit's handle or by the
increase/decrease button located next to the display. The
digital control panel will flash upon each press.
3. Press the button on the metal tube to adjust the length.
4. Press the on/off button to turn off.
5. To rewind the power cord, remove from the power outlet and
press the rewinding cord button.
Replace the dust bag:
• Replace the dust bag when the dust indicator turns red.
• Open the front cover and insert a dust bag by fitting the tabs of
the bag into the compartment.
Cleaning the HEPA filter:
• Open the filter cover on the back and remove the HEPA filter
by pulling the tab on the HEPA filter downwards.
Rinse under running water allow to dry then replace.
Maintenance of the motor protection filter:
• The protection filter of the motor is located in the dust bag
compartment and should be cleaned or replaced when dirty.
Clean the exterior of the vacuum cleaner:
• Wipe the exterior of the vacuum cleaner, hose and attached
brush with a damp towel.
Note: Do not use any abrasive cleaning products or scouring
pads to clean any part of the vacuum cleaner. This may
damage the surfaces of the vacuum cleaner.
8
ΕΝ