JAROLIFT TDRC01W Instrucciones Originales página 16

PROGRAMMING
For setting the end positions of the controlled radio drive as well as for further settings or programming steps you need the
instructions for the respective radio motor or external radio receiver!
INITIAL PROGRAMMING TDRC01W / TDRC02W
The example shown is exemplary and depends on the respective receiver type. Please refer to the instructions of the receiver!
NOTE!
Each key must be pressed (held) for approx. 1 second!
Each programming step must be carried out within approx. 10 seconds.
Otherwise, the system automatically exits the programming mode. If necessary, start from the begin-
ning.
1. Set the desired radio receiver or radio motor to programming mode according to the associated instructions.
2. Press the up and down buttons of the wall transmitter simultaneously within approx. 10 seconds.
3. Then immediately press the stop button on the wall transmitter.
4. Successful teach-in is acknowledged by a short vibration of the tubular motor connected to the radio receiver or the vibra-
tion of the radio motor.
Set the receiver to pro-
gramming mode accor-
ding to the instructions.
Receiver according to inst-
ructions to the programm-
ing mode according to the
instructions.
If you want to control more receivers with this transmitter/channel, repeat the procedure.
ATTENTION!
Check the function with the UP/STOP/DOWN buttons on the wall transmitter.
If the direction of rotation of the motor is incorrect (roller shutter / motor moves downwards when the UP but-
ton is pressed), the direction of rotation of the motor must be changed.
Please refer to the chapter "Changing the direction of rotation" of the respective radio motor or radio
receiver.
16
max. 10 sec.
max. 10 sec.
Press the up/down but-
ton simultaneously, then
press the stop button.
Press the up/down key of
the desired channel (1 or
2) simultaneously, then
press the stop key of the
desired channel.
(Engine vibrates)
(Engine vibrates)