Kobalt 19000 Manual Del Usuario página 9

ASSEMBLY INSTRUCTIONS
7. Install the bottom shelf (G) by tipping it to
the side and inserting it into the cabinet.
With bottom shelf (G) at an angle, align
the cut-outs on the bottom shelf (G) with
the back seams caused by side panels (C
and D) and back panels (A and B).
Carefully lower the bottom shelf (G),
ensuring the front of the bottom shelf (G)
goes over the front flange of the base
panel (E).
Determine the location for the other 3
adjustable shelves (H). Hold the
adjustable shelves (H) at an angle to
make them easier to install. Repeat
above method to install. Please make
sure adjustable shelf (H) snaps into the
hooks on the unit.
Note: If the hooks are flatted during
assembly, use a slotted screwdriver (not
included) to recover them.
8 . Lift and pull the L-shaped pivot pin on the
edge of the left door (I), aligning the
assembling holes of the base panel (E)
and top panel (F), then release. Repeat
for right door (J).
Note: Check and see if the top panel (F) is
level. If not level due to uneven floor, the
two doors will probably not be properly
aligned. In this case, use an adjustable
wrench (not included) to adjust the hex nut
until the top panel (F) is level.
7
C
H
G
E
8
I
E
9
C
H
A
D
F
J