Publicidad
Idiomas disponibles
Idiomas disponibles
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2 - 3
Fig. A
1. Machine
2. Battery
3. Battery unlock button
4. Work light
5. Charger
6. Charger LED indicator
7. Chuck
8. Gear selection switch
9. Direction switch
10. On / off switch
11. Torque adjustment ring
12. Belthook
3. OPERATING
The battery must be charged before first
use.
Removing the battery from the machine
Fig. B
• Push the battery unlock buttons (3) and pull
the battery out of the machine.
Inserting the battery into the machine
Fig. B
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• Insert the battery (2) into the base of the
machine.
• Push the battery further forward until it clicks
into place.
8
Charging the battery with the charger (Fig. C)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (5) as shown in Fig. B.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (6) will lighten up and show the
charger status.
The charger has 2 LED indicators (6) which
indicate the status of the charging process:
Red LED
Green LED
Charger status
Status
status
Off
Off
No power
Off
On
Standby mode:
- No battery is inserted or,
- Battery inserted but charging
has finished
On
Off
Battery charging in progress
• Fully charging the 2Ah battery may take up to
80 minutes.
• Fully charging the 4Ah battery may take up to
160 minutes.
• After the battery is fully charged remove the
charger plug from the outlet and remove the
battery from the charger.
When the machine is not being used
over a longer period of time it is best to
store the battery in charged condition.
Fitting and removing drills or screwdriver bits
Fig. D
Always remove the battery before
mounting an accessory.
The drill chuck (7) is suitable for drills and screw driver
bits with round shaft as well as hexagonal shaft.
• Hold the machine firmly with one hand
• Open the drill chuck (7) by rotating the chuck
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
• Insert the shaft of the drill or screwdriver bit
• Tighten the drill chuck again by firmly rotating
the chuck (7) counterclockwise.
• Check if the bit is centered well by shortly
activating the machine´s on/off switch.
Publicidad
