Publicidad
Idiomas disponibles
Idiomas disponibles
8. [ CITY ]
Press once to toggle between the sunrise and sunset time of a pre-set city in a specific day.
The icon
is displayed to prompt for sunrise time and the icon
sunset time.
Press and hold 2 seconds to enter city setting mode, use [ ] and [ ] to select the abbreviation of country name
and then the city name according to the list in the appendix, press [CITY] button to confirm. Use [ ] and [ ] to
select the DST (Daylight Saving Time) 'ON' or 'OFF', press [CITY] button to confirm.
9. [ CLOCK ]
Toggle amongst display for Clock-Sec (HR-MIN-Sec), Clock-day (HR-MIN-Weekday), Calendar (Date-Month-Year),
alarm time and repeat...
10.[ MODE ]
Press & hold 2 seconds to enter backlight color setting mode.
Slide switch [BACKLIGHT] on the rear side to select the backlight mode
Slide switch Position
Auto
OFF
ON
GETTING STARTED
This Weather Station was designed for easy set up. For best operation, the following steps are required to be done in
the proper sequence.
1. INSERT BATTERIES FOR MAIN UNIT BEFORE DOING SO FOR THE SENSOR UNITS.
2. RECEIVING UNIT CANNOT BE SET MANUALLY UNTIL THE WIRELESS REMOTE SENSOR UNIT REGISTRATION
PROCEDURE HAS BEEN COMPLETED.
3. POSITION THE REMOTE UNIT AND MAIN UNIT WITHIN EFFECTIVE TRANSMISSION RANGE, WHICH, IN USUAL
CIRCUMSTANCES, IS 75 METERS.
Although the remote unit is weather resistant, it should be placed away from direct sunlight, rain or snow.
BATTERY INSTALLATION FOR MAIN UNIT
1. Turn the metal nut anti-clockwise on the bottom of the unit to open and release the battery compartment .
2. Insert 4 AA size 1.5V alkaline battery as indicate by the polarity.
3. Push the battery compartment back, turn the metal nut clockwise to lock.
Note: Replace the batteries when the low battery indicator appears on the top-right corner of the
LCD.
WIRELESS REMOTE SENSOR REGISTRATION PROCEDURE
1. Insert x4 AA batteries first to the main unit, the outdoor temperature display shows --.- While the wave icon will
keep blinking for 2 minutes indicate unit is in sensor searching mode.
2. In a second step, insert the x2 AAA batteries for the sensor unit. The LED on the front panel will start flashing
at a rate of one time per around 2 seconds indicates channel-1 is in use.
3. While the LED in the sensor unit is flashing, press once the [CH] key will change the sensor channel setting to 2.
Keep toggle on [CH] key can change channel setting up to 5. The LED is blinking at a frequency to indicate the
channel setting. i.e. continuous blinks 2 times indicate channel-2 is selected.
Note : If user does not press any key for 10 seconds, it w ill exit the channel setting mode and
transmit the RF signal. The main unit will register the temperature reading. (If the transmitter has
the LCD display, th e C/F key w ill toggle the tempera ture unit on the LCD.)
REMOTE CHANNEL AUTO-SCROLLING
This device is equipped with an auto-scroll function. While the auto-scroll function is set, the unit will automatically
cycle to display the temperature of each remote sensor for 6 seconds.
.
1
To retrieve manually the specific sensor temperature reading, press CHANNEL key until desired channel number
is displayed.
.
2
To enable auto-scroll function, use CHANNEL button to select channel 1, 2, ... until auto scroll icon appears on
the left hand corner of the 3rd line display.
Power Supply
Battery Only
Wave hand in front of the IR sensor to activate backlight for 5 seconds
Disable the backlight function
Wave hand in front of the IR
sensor to activate backlight
for 5 seconds
Battery & Adapter
Backlight always on
17
is displayed to prompt for
Adapter
Publicidad
