Work Pro W MD 82 AX Manual De Uso página 5

2.3 Choosing Wire and Connectors
We recommend using pre-built or professionally wired balanced line (two-conductor plus shield)
22-24 gauge cables to connect the balanced input by using the included Euroblock connectors,
see Figure 2.3. Unbalanced lines may be used, but may result in hum or RF noise very long cable runs.
NOTE: Custom wiring should only be performed by qualified personnel.
Figure 2.3 Input and Output Wiring
INPUT CONNECTOR
EUROBLOCK CONNECTORS
BALANCED LINES
UNBALANCED LINES
2.4 Wiring Your Audio System
Professional audio system
Figure 2.4
OUT1
G
2.4 Wiring Your Audio System
Typical input and output wirings are shown in Figure 2.4.
INPUTS: Connect input wiring for both channels using the Euroblock input for each channel.
OUTPUTS: The mixer's line level output may be connected to the input of a power amplifer .
RS485: Connect an external device which generates control commands
ON OFF
AUDIO
SOURCE
ON OFF
AUDIO
SOURCE
48V
ON OFF
OUT2 MIXING CH8 CH7
G G G G
4
OUTPUT CONNECTOR
AUDIO
SOURCE
48V 48V
ON OFF ON OFF
CH6 CH5 CH4 CH3
G G G G
User Manual / Manual de uso
48V
ON OFF
CH2 CH1
G G
MD 82 AX
EN