Huepar DT03CG Manual Del Usuario página 11

Note:
• When using under Self-leveling mode, please place this laser
unit on a level surface.
！
• When the laser unit is out of self-leveling range (±3.5°), the
indicator LED (17) will flash rapidly and the laser beam(s) blink
fast.
• Laser lines can be switched on/off individually with the
Slope Function ≤ 3.5°
1. Horizontal leveling adjustment up to a max. of 3.5° :
A. Adjustment of the X axis up to a max. of 3.5°
Step 1: Press and hold the button
function LED（18） flashes rapidly. Motor-driven adjustment of the
slope is now enabled.
Step 2: Keep pressing and holding the
slope. When the lasers blink, the maximum slope range (3.5°) has
been reached.
B. Adjustment of the Y axis up to a max. of 3.5°
Step 1: Press and hold the button
function LED（18） flashes rapidly. Motor-driven adjustment of the
slope is enabled now.
Step 2: Short press the button
function LED (18) flashes slowly.
buttons (press buttons shortly).
3 sec.
for ≥3 seconds until the slope
or
for ≥3 seconds until the slope
to switch to Y axis. The slope
-10-
button to adjust
or