Huepar LR-5RG Manual De Instrucciones página 10

At LOUD volume level, the audio signal indicator appears
•
At SOFT volume level, the audio signal indicator appears
•
When the audio signal is set to MUTE, the indicator goes out.
•
Note: Position the receiver at least 17ft (5m) away from the laser level.
With the receiver on, position the receiver to where the laser beam can
•
reach the laser reception window (5). Align the receiver so that the laser
beam can run laterally through the laser reception window (5).
Use the bubble vial to maintain a level plane with the receiver.
•
Be sure that the laser reception window (5) is facing the direction of the
•
laser beam.
beam:
If the Upper Indicator lights up, move the receiver down to match the
•
center indicator (c) because it indicates that the laser line is above the
center mark.
If the Lower Indicator lights up, move the receiver up to match the
•
center indicator (c) because it indicates that the laser line is below the
center mark.
If the center Indicator lights up, it indicates that the laser line just
•
matches the center mark.
A beep sounds to indicate that the laser beam has been detected.
•
A fast beep sounds to indicate that the receiver must be moved down.
•
A slow beep sounds to indicate that the receiver must be moved up.
•
A steady beep sounds to indicate that the laser beam is aligned with
•
the center mark on receiver.
.
-8-
.
.