Publicidad
Idiomas disponibles
Idiomas disponibles
ARKO FLUX 100
3. START-UP. ADJUSTMENT AND OPERATION CONTROLS.
3.1 START-UP. PREVIOUS OPERATIONS.
Before starting the system up, the following steps must be taken:
1)
Make sure the main voltage matches the one established by the machine.
2)
Connect supply cable to the electrical power outlet.
3)
Fit the wire reel into the wire reel support axle.
4)
Fit the wire into the driving system.
3.2. OPERATING CONTROLS.
Luminous ON/OFF switch.
1º)
Thermal overload indicator.
2º)
Wire speed control potentiometer.
3º)
Power cable inlet socket.
4º)
4. MAINTENANCE OPERATIONS. RECOMMENDATIONS.
Before carrying out any operation on the machine or gun, we must disconnect the machine from the power
supply.. Specialized personnel must handle the machine to carry out maintenance and repair operations.
BLOW THE INSIDE OF THE MACHINE WITH COMPRESSED AIR FROM TIME TO TIME.
-
PLACE THE EQUIPMENT SOMEWHERE WHERE CLEAN AIR IS RENEWED.
-
KEEP THE MACHINE PANELS CLOSED.
-
DO NOT DISCONNECT THE MACHINE IF IT IS HOT.
-
-
KEEP THE WELDING GUN IN GOOD CONDITIONS FOR USE.
8
Publicidad
