Outfit 93525 Manual De Instrucciones página 18

GAS BLOW TORCH
Model
Gas type
Supply pressure (bar)
Nominal heat output (kW)(Hs)
Nozzle size (mm)
Ignition method
*To be used with a 190 butane gas cartridge
This appliance is to be used with a 190
gram butane gas cartridge or a butane/
propane mix. It must only be used in
a location with adequate ventilation.
SAFETY REQUIREMENTS FOR THE USE AND
MAINTENANCE OF THE GAS BLOW TORCH
There is a risk of gas leakage when the gas
blow torch is ignited for the � rst time or if it
has been shaken. However, the leak will be
short-lived and should not give rise to panic.
Do not make any changes to the appliance.
• The manufacturer assumes no
responsibility for problems as a result of:
Incorrect use of the appliance
Careless use of the appliance
Modi� cation or conversion of the
appliance
Installation of an incorrect accessory (gas
cartridges, valves, seals)
• This appliance is only intended for use
with 190 gram butane gas cartridges or a
butane/propane mix.
• Read the instructions on the gas
cartridge carefully before � tting it.
• This appliance is intended for outdoor
use only. The gas cartridge must always
be installed and removed outdoors.
• Caution! Butane gas is dangerous!
18
93525
Butane
Direct
1.3
0.30
Piezo ignition
• Keep the appliance out of the reach of
children.
• Do not use the appliance if the seal is in
poor condition.
• Do not use the appliance if gas leaks out
of it, if it is damaged or if it is not working
properly.
• In the event of a gas leak, the appliance
must be placed outdoors at a safe
distance from naked � ames and other
sources of ignition. Find the leak
outdoors using soapy water. Never use a
naked � ame to locate a gas leak.
• The supporting surface for the appliance
must be level.
• The appliance must not be used close to
� ammable materials.
• Check that the regulator for the gas valve
is fully closed before � tting or removing
the gas cartridge.