Publicidad
Idiomas disponibles
Idiomas disponibles
Main parts of the product
GB
(Fig.1 on page 3)
1. Crumbs tray
2. Glass doors
3. Light source
4. TURN switch: Control the motor
5. HEAT switch: Control the heating of the kettle
6. WARMING & LIGHT switch: Control the warming ele-
ment(bottom of the chamber) and light
7. POWER switch
8. Kettle grip
9. Kettle lid grip
10. Kettle
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
ATTENTION! Do not pop corn kernels in a dry pot (without oil).
• To avoid overheating, always have oil and kernels ready before
operating.
• Make sure the light bulb is installed.
• Turn on the device using the POWER switch.
• Turn on the light using WARMING & Light switch.
• Pour 50ml oil into the kettle. Turn on the heater for kettle
using HEAT switch to preheat for 4-6 minutes.
• Lift the kettle lid using the lid grip carefully and pour 50g sug-
ar (while the amount is dependent upon your taste) and 150g
corn kernels.
• Put the lid down and close the glass doors firmly to avoid
spilling of popcorns from the appliance.
• Pay attention to the corn kernels while popping process to
avoid burning.
• Turn on the motor using TURN switch to stir the corn kernels
until there are all popped, then pour the popcorns out from
the kettle to the chamber using kettle grip carefully.
• The popping cycle is approx. 2 minutes per portion.
• Fix the kettle in horizontal position again and repeat upper
procedures to make more popcorns.
Note:
• The appliance is equipped with "protective thermostat". In
case of overheating of the kettle, the protection will be ac-
8
tivated and turns the appliance off. Disconnect the appliance
from the electrical socket and wait for cooling down. Then, it
may be used again.
• Do not put too many corn kernels at one time for even spacing
and cooking.
• Do not drop any oil around the plate. Otherwise it will catch
fire when it is heated to a certain temperature.
• WARNING! Do not add any water to the plate while it is pop-
ping!
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for cleaning.
Do not use petrol or solvents!
• No parts are dishwasher safe.
Parts
How to clean
All accessories
• Soak in warm, soapy water
such as trays,
for about 10 to 20 minutes.
tray handle,
• Rinse under running water
tray holders
thoroughly.
External
• Wipe clean with a soft cloth
housing
and a little mild detergent.
Make sure no water or
moisture enters inside of
the appliance.
Inside of the
• Remove any food deposits.
appliance
• Wipe with a damp cloth and
a little cleaning detergent
Glass door
to remove any spills or
splatters.
• Note: Be sure not to dam-
age the heating elements.
Remark
Dry all parts
well at last.
Publicidad
