Publicidad
Idiomas disponibles
Idiomas disponibles
LOCATION OF CONTROLS
•
1. Switch OFF
•
2. Flame function - Switches flame effect and power on
•
3. Heat function - Low heating power 900W (With flame effect)
•
4. Flame function - Switches flame effect brighter (With low heating power)
•
5. Heat function – High heating power 1800W (With more bright flame effect)
•
6. Adjustable Thermostat - mechanic thermostat room temperature control
Installation
Installation of feet
Take out the whole machine, and put it on the flat table in order to avoid machine scratching,
then take the feet out of the plastic bag and connector (as shown in the picture), the three
foot which marks A,B,C should fix on the match position:
Overheating safe device
If the heater stops working, turn the heater off and inspect the blockage of inlet or outlet.
Disconnect the plug and wait at least 15 minutes for the protection system to reset before
attempting to restart the heater. If the safe device still switches the heater off and makes the
heater fail to operate, take the heater to your nearest service center for examination or repair.
Attention: before restarting the heater, the plug must be disconnected for at least 15
minutes
18
Publicidad
