Descargar Imprimir esta página

MO-EL 2473 Uso Y Mantenimiento página 3

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 6
EN
IMPORTANT SAFETY INSTRUCTIONS
Before using the upright , read carefully the instructions contained in this booklet,
which furnish important information regarding installation, use and maintenance safety.
The booklet must be keeped and delivered to the new user in case of cession of the
machine.
1. The upright is intended exclusively for the use for which it was created,
that is the mounting of "Fiore" heater, and the producer would not be
considered responsible for any damage caused by its improper use.
2. After unpacking, make sure that the appliance is complete and shows
no signs of visible damage or tampering.
3. Keep packing materials, which are potential dangers, away from
children (plastic bags, styrofoam packing pellets, nails, etc.).
4. The upright is not suited for persons (as well as children) physically,
mentally, sensory disabled, or with no experience, unless they have
been supervised or directed by someone responsible of their safety.
5. Do not bring modifications to the product that compromise the safety.
LOCATION (WITH "FIORE" HEATER)
• The upright must lean on a horizontal surface and the ground must be stable and
solid.
• Fix the screw anchor on the ground at the chosen point.
• Open the feet almost to reach the white line on the bottom of the tube.
• Hook the ring of the chain to the screw anchor.
• Open the upright until the junction of the feet reaches the white line, tightening the
chain (fig.1).
• For fixing the heater, use the braket with the omega hooks (art.768P - provided
separately). The upright bracket is studied for holding one appliance or two of them
in opposite position (please see fig.2).
• The heaters should always be installed horizontally only using the mounting brackets
provided. This ensures correct positioning and adequate clearance.
• The heater should be mounted at a minimum of 180 cm above ground level (fig.3).
• A minimum air gap of 40 cm should always be allowed between the top of the
heater and a ceiling or roof. The appliance should be 60 cm far from the walls (fig.3).
• A safety distance of not less than 100 cm should always be left in front of the
"Fiore" heater or too near.
• Be sure that the heater is not facing the ceiling or inflammable substances.
For the assembly and the installation of the "Fiore", follow the rules in the
instructions booklet of the heater.
USE AND MAINTENANCE
3

Publicidad

loading