Publicidad
Idiomas disponibles
Idiomas disponibles
HALO Home Smart Lights are designed for wireless dimming only. For best result, install with HALO Home Wireless Controllers
like the Accessory Dimmer or Accessory Switch. Can be installed with standard ON/OFF switches but not recommended due to
accidental factory resets.
These downlights are canless and mount directly to the ceiling. They do not require an additional junction box or recessed
housing and are rated for contact with insulation.
1
Determine how many downlights (A)
will be installed with the Remote Driver
Box (D) - Max. 70W
MicroEdge HLB Fixture Count
MicroEdge
Watts per
Model
Downlight
HLB 4"
7.2 W
HLB 6"
11.6 W
3
Unlatch the hinge on the Remote Driver
and open the cover of the junction box.
Using a flathead screwdriver, open the
black plastic Slide-N-Side strain reliefs
or remove metal knockouts and attach
a wire clamp. Insert wires through the
preferred strain reliefs.
6
Route the low voltage cable to additional downlight locations.
Pull enough slack through each hole to make connecting the
fixtures easier. Bundle and store remaining cable in the
ceiling.
DIMMING OVERVIEW
DO NOT use with other manufacturer's dimmers.
2
Carefully measure where each fixture will be installed, trace the provided
template and cut openings in the ceiling.
Maximum
Downlights
9
6
4
Connect the ground, white, and
black wires from the wiring
compartment to the appropriate
supply wires using push-in
connectors and close the cover.
v
INSTALLATION
WIRING
7
Attach the termination cap (F) to the end of the low voltage
cable. Use the reusable cable tie to bundle the remaining cable
and store it in the ceiling.
DO NOT CUT
Hole Saw Sizing
Min to Max
HLB 4"
4" to 4-3/16"
HLB 6"
5-3/4" to 6"
5
Place the Driver Box thru the opening
and latch the junction box to the driver
box. Mount to structure if required by
code.*
IL518128ML
April 27, 2021 3:28 PM
Publicidad
