Publicidad
Idiomas disponibles
Idiomas disponibles
PARTS DESCRIPTION
Fig. 4
1. power supply selector
2. Receiver connection terminal block
3. Transmitter connection terminal block
4. Fixing holes
5. Synchronism jumper
6. Led on when transmitter is powered
7. Led on when the transmitter and receiver are out of aligment
8. Internal casing fixing screws
9. Cable entrance
10.
Vertical adjustment
11.
Horizontal adjustment
INSTALLATION
The equipment should be installed expertly by people with the
necessary requirements as established by the laws in force in
the country of installation.
The receiver and transmitter must be located one in front of the
other and fixed so as to be as accurately aligned as possible. In the
case of errors or in extreme cases, the inside bodies of the
photocells can be slanted vertically or horizontally ± 5°.
ASSEMBLY (fig.3):
A. Fasten the outside containers in order to obtain optimum
alignment between the transmitter and receiver.
B. Insert the two sides and carry out the electrical connection.
C. Complete the cover with the rubber profile, and remember that
for a better seal, the joining point should be on the bottom
GB
(fig.2)
.
19
Publicidad
