Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Inflator does not turn on:
1. Check the fuse. It may have blown:
•12V fuse is located in the plug adapter. To replace,
unscrew the tip, remove fuse, and inspect. If necessary,
replace fuse with 15A, 250V (5mm×20mm).
•120V fuse is located on the side of the cord storage. Unscrew
fuse cap, remove fuse and inspect. If necessary, replace fuse
with 2A, 250V (5mm x 20mm).
2. Check vehicle's power outlet fuse; it should be a minimum of 15
amps.
3. Check receptacle and plug terminals for dirt (particularly
tobacco). Use a non-conductive probe (not fingers or metal) to
dislodge and remove debris.
4. Push the power plug firmly into the receptacle and twist it back and forth.
5. The Inflate-Right™ pressure may be set at/or below the desired pressure. Reset.
Inflator runs but does not inflate:
1. Be sure the air hose connector is tightly screwed onto the valve stem.
2. Check tire for leaks. Check hose for breaks and leaks at fittings.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool for 25
minutes.
2. The voltage may be too low. Check the condition of your vehicle's battery.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim allowing
air to leak out when trying to inflate. In the event this occurs, it may be necessary to jack up the
tire prior to inflation.
Dispose of this product at an e-waste recycling collection point or facility.
Do not place in the trash or standard recycling receptacle.
120VAC, 60 HZ, 1.4A OR 12VDC 9A ,ON/OFF: 4 MIN/20MIN,
FOR WARRANTY INFORMATION GO TO: WWW.SLIME.COM / WARRANTY
QUESTIONS OR COMMENTS: Call (888)457-5463 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime
is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.
®
MAX RATED PRESSURE: 60PSI
Publicidad
