Publicidad
Idiomas disponibles
Idiomas disponibles
The new superheterodyne receiver always guarantees a correct
functioning in disturbed environments: its good sensitivity and
high selectivity make it immune from most disturbances around
the frequency reception area. The new self-learning programming
system enables the memorization of the DOTTO / MINI PLUS
series transmitters.
• It is possible to store up to 240 different codes
• Remote radio acquisition
• Complete deletion of remote codes
• Memory full warning: the receiver blinks 15 times.
RADIO ACQUISITION
• Press P1 push-button of the receiver: L1 led switches on.
• Release the push-button, the led switches off and it sends out
a sequence of single flashings for 5 seconds: the number of
short flashings shows the selected channel.
• To select the further channels press and release the P1
push-button within 5 seconds, the led changes type of
flashing according to the following table:
N°
SELECTED
Impulses
CHANNEL
P1
CHANNEL 1
1
CHANNEL 2
2
CHANNEL 3
3
CHANNEL 4
4
• Choose the channel you want to memorize and within
5 seconds press and hold the push-button of the transmitter.
• The LED of the receiver switches off and it switches on again:
this means that the code has been memorized and the
receiver will wait for a further code to memorize for a
maximum time of 5 seconds.
REMOTE RADIO ACQUISITION
PLEASE NOTE: The DOTTO transmitter allowing this
function to be enabled must be already memorised.
This procedure allows new transmitters to be memorised via
radio, sequentially, without removing the receiver from the
installed system.
All transmitters memorised by radio will have the same
transmitter key logic that activated programming.
1. Set transmitter switch 1 to ON.
2. DOTTO multichannel only: Press the transmitter SELC key
several times until the channel desired is shown by the LEDs
3. Press and hold the PROG key (for approx. 7 seconds) on the
remote control unit already memorised until LED L1 on the
receiver flashes
4. Within 5 seconds, transmit using the new remote control to
be memorised
5. LED L1 comes on for 2 seconds to indicate memorising has
occurred, and then starts flashing for a further 5 seconds
while waiting for another remote control to be memorised
PLEASE NOTE: Using this procedure, within the memory
capacity limits, it is possible to insert all the desired
transmitters in sequence.
6. Wait for LED L1 to be turned off to exit programming mode
Flashing
single
double triple
quadruple
•
••
•••
••••
FULL CODE ERASING
To perform a full code erasing do the following:
1. Switch off the power supply of the control unit where the
PLUS receiver is connected.
2. Press and hold pressed the P1 key of the receiver
3. At the same time turn on the power again. The receiver LED
goes on: release the P1 key.
The memory spaces are empty and available for a new
programming.
COMPLETE DELETION OF REMOTE CODES
PLEASE NOTE: The DOTTO transmitter allowing this
function to be enabled must be already memorised.
1. Set transmitter switch 3 to ON
2. Press and hold the transmitter PROG key until LED L1 comes
on for 1 second and then turns itself off to indicate deletion
has occurred
99/05/CE DIRECTIVE CONFORMITY
The PLUS is in conformity with the provisions of the following EC
directive(s) (including all applicable amendments) and that the
standards referenced here below:
EN 60950-1, EN 301 489-1, EN 301 489-3, EN 300 220-3
Carrugate, 12/01/2010
CIBOFER INTERNATIONAL s.r.l. legal representative
Stefano Ciriello
Publicidad
