Taurus ALPATEC NEW BABEL DIGITAL Manual Del Usuario página 6

English
TOWER FAN
NEW BABEL DIGITAL
DESCRIPTION
1 On/off
2 Speed setting
3 Oscillation
4 Mode setting
5 Timer
6 Screen brightness
USE AND CARE:
- Fully extend the appliance's power cable befo-
re each use.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
- Do not use the appliance if the on/off switch
does not work.
- Do not remove the support feet of the applian-
ce.
- Do not move the appliance while in use.
- Use the appliance handle/s, to catch it or move
it.
- Do not use the appliance if it is tipped up and
do not turn it over.
- Do not turn the appliance over while it is in use
or connected to the mains.
- mains when not in use and before undertaking
any cleaning task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Keep the appliance in a dry, dust-free place,
out of direct sunlight.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the appli-
ance from operating correctly.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry pets or an-
imals.
- Do not use the appliance to dry textiles of any
kind.
INSTALLATION
- Ensure that the fan is switched off from the
supply mains before start any installation or
assembly operation.
- Do not remove the support feet of the applian-
ce.
- Ensure that the appliance is level with respect
to the floor.
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.
- The appliance should be used with its base
fitted.
- The appliance should be used with its base
feet fitted.
ASSEMBLING THE BATTERY/S
- The remote control uses a CR2025 3VDC
lithium battery.
- This battery is non-rechargeable. Do not
attempt to recharge it.
- Caution: During the handling of batteries, do
not touch both poles at the same time, as this
will provoke the partial discharge of the stocked
energy therefore affecting longevity.
- Caution: The supply terminals are not to be
short-circuited.
- Remove the cover of the battery compartment.
- Check that the plastic covering that protects
the battery has been removed (some batteries
are sold with a protective covering)
- Put the battery in its compartment, respecting
the polarity
- Replace the cover of the battery compartment.
- N.B. When changing the batteries, the confi-
guration of the appliance will be removed, and
you will need to reset the parameters of the
appliance.
ASSEMBLING THE BASE:
- Fit the base with the column and secure it with
the screws provided (Fig.1).