DINUY EM HEB 001 Instrucciones De Uso página 3

EN
INSTRUCTIONS MANUAL
Ref. EM HEB 001
BELL-PUSH EXTRA FOR DOORCHIME HELIOS
FUNCTIONING
● Transmitter pushbutton:
Learning with TI HEB K26
1
● Back of the doorchime:
● Aprendizagem:
1.- Place the batteries according to the indicated polarity (+/-).
2.- Turn-on the doorchime and, with the help of a thin point, do
a short pulsation (1sec) in the "learning/erasing" hole.
From that moment, and for 30sec, the led will keep
turned-on and the doorchime will be ready to receive the
transmitter's code during that time..
3.- Press the pushbutton until the doorchime sounds. This will
indicate that the learning process has been done correctly.
After it the doorchime will go automatically to its normal
mode.
4.- In case that more than 30seconds had gone by without
doing the process, repeat the procedure.
● Code erasing: If is required to erase the learned codes, it is
necessary to press the "learning/erasing" hole with a thin point
for more than 4sec. When the code is erased, the led will flash
twice, showing that the process has been done correctly.
Learning with TI HEB K27 - Plug-in extra doorchime
2
● Back of the doorchime:
● Learning:
1.- Plug in the doorchime to the power supply employing a
lengthening in order that the learning orifice comes visible,
with the help of a thin point, do a short pulsation (1sec) in
the "learning/erasing" hole. From that moment, and for
30 sec, the led will keep turned-on and the doorchime will
be ready to receive the transmitter's code during that time.
2.- Press the pushbutton until the doorchime sounds. This will
indicate that the learning process has been done correctly.
After it the doorchime will go automatically to its normal
mode.
3.- In case that more than 30seconds had gone by without
doing the process, repeat the procedure.
● Code erasing: If is required to erase the learned codes, it is
necessary to press the "learning/erasing" hole with a thin point
for more than 4sec. When the code is erased, the led will flash
twice, showing that the process has been done correctly.
DINUY, S.A. Auzolan, 2, 20303, IRUN, SPAIN
● Powered by a 3V. battery, type CR2032 (included).
● Clear range: 200m.
● It can be installed outdoors or indoors, but never on
a metallic surface. It can be fixed to the doorframe or
wall with two screws.
Metallic obstacles, walls and so, can
reduce its range.
Declaration of conformity CE
Guarantee
www.dinuy.com
O N
1
2
Battery
-
Portable extra doorchime
Learning /
Code erasing
Learning /
Code erasing
Switch
ON
1 2