Conel BSS 18VC0 Instrucciones De Funcionamiento Originales página 18

Instructions for use
Before initial operation
 Unpack the power tool and accessories
and check that no parts are missing or
damaged.
 Attach the belt clip and bit holder with
the enclosed fastening screw.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully.
Fitting/removing the auxiliary handle
CAUTION!
Use auxiliary handles if these are supplied
with the power tool. The loss of control may
result in injuries.
18
Changeable drill chuck BF 18.0-EC
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
Assemble
 Pull unlocking ring forwards (1.) and
press the drill chuck all the way onto the
tool holder (2.).
 Release unlocking ring. Check that the
drill chuck is locked in position.
Disassemble
 Pull unlocking ring forwards and remove
the drill chuck.
Inserting the tools
Drill bits with a diameter of 1.5–13 mm,
½
" screwdriver bits and
securely held in the drill chuck.
 Grip the power tool firmly with one hand
and turn the chuck with the other hand.
– Turn counterclockwise to open the chuck
further.
– Turn clockwise to close the chuck.
 Insert the tool.
 Close the chuck fully.
NOTE
Carry out a test run to check that the tool is
chucked in the centre.
BS 18VC0 / BSS 18VC0
½
" bit holders are