Assembling The Cleaner; Hose Assembly - Pentair KREEPY KRAULY BLUEREBEL Guia De Instalacion

ASSEMBLING THE CLEANER

The BLUEREBEL™ Suction Side Pool Cleaner body is shipped as
one piece, making cleaner assembly a simple and quick process.

Hose Assembly

For best results and to maintain proper operation, use only
original Pentair parts and hoses.
1. To connect the hose sections, wet the ends in the pool
water, then twist and push the female ends onto the
male ends.
Figure 2
2. Connect the leader hose to the cleaner swivel. See
Figure 3.
Note: The leader hose is 36 centimeters (14 inches) in
length and shorter than the other sections included in
the hose set. Failure to use this leader hose section will
hinder cleaner performance
3. The hose should reach from where the cleaner is
connected to the farthest point of the pool, plus one
section and the leader hose.
4. Install the hose float onto the second length of hose.
The float should be placed 50.8 centimeters (20 inches)
above the cleaner. See Figure 4.
5. Make sure that all connections are snug.
6. The overall length of hose needed will be determined
by the distance from the point at which you attach the
hose to the suction port to the furthest point in the
pool, plus one length and the leader hose. Refer to
Figure 5.
Figure 3
Figure 4
5
Leader
Hose
Swivel
Assembly
50.8cm
(20 in)
Figure 5