Electrolux EFV536K Manual De Instrucciones página 30

30 www.electrolux.com
Keep the hood
clean
Charcoal filter
4.2 Cleaning the grease filter
Filters are mounted with the use of clips
and pins on the opposite side.
To clean the filter:
1. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
2
2. Slightly tilt the front of the filter
downwards (2), then pull.
Repeat the first two steps for all filters.
3. Clean the filters using a sponge with
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
Clean the appliance and grease filters each month. Clean the inte‐
rior and grease filters carefully from fat. Fat accumulation or other
residue may cause fire.
Follow the instructions for cleaning the accessories when filter noti‐
fication is on. Refer to Filter notification in daily use chapter.
Grease filters can be washed in a dishwasher.
The dishwasher must be set to a low temperature and a short cy‐
cle. The grease filter may discolour, it has no influence on the per‐
formance of the appliance.
The time of saturation of the charcoal filter varies depending on the
type of cooking and the regularity of cleaning the grease filter. The
activated charcoal filter is not washable, cannot be regenerated
and must be replaced approximately every 4/6 months of operation,
or more frequently for particularly heavy usage.
1
4. To mount the filters back follow the
first two steps in reverse order.
Repeat the steps for all filters if
applicable.
4.3 Replacing the charcoal filter
The charcoal filter must be replaced if
the filter alarm is on.
Refer to the filter notification
in daily use chapter for more
information about function.
WARNING!
The charcoal filter is NON-
washable! The filter cannot
be regenerated!
To replace the charcoal filter:
1. Remove the grease filters from the
appliance.
Refer to "Cleaning the grease filter" in
this chapter.
2. Turn the filter counterclockwise (1)
and then pull (2).
To mount the filters back follow the steps
in reverse order.
1
2