Power Dynamics PD1212 Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. Treble
Adjust tone control for treble of respective channel.
2. Bass
Adjust tone control for bass of respective channel.
3. Effect
Microphone effect for channel 1 or 2.
4. Volume
Adjust the signal level of respective channel.
5. Line/Mic Selector
When using channel 1 or 2 as a microphone channel,
bring the Mic/Line Switch to the down position.
When using channel 1 or 2 as an instrument channel,
bring the Mic/Line Switch to the up position.
6. XLR Input
Microphone or instrument input（XLR）for channel 1 or 2.
7. Echo
Digital echo effect controller.
8. Line Input
Instrument input 6.35 mm jack or RCA Line input.
9. Monitor output
RCA jack output for connecting audio units with line level output (e.g. mixer, monitor, CD player, tape recorder).
10. Subwoofer
Volume controller for subwoofer.
11. 45/63Hz Switch
When using 45 Hz, bring the switch to the down position. When using 63 Hz, bring the switch to the up position.
12. Master volume
Volume control of overall output signal.
13. VU meter
Indicator for left or right signal representation.
14. Graphic Equalizer
5-band equalizer for the master signal. Adjust frequencies
are 100Hz, 500Hz, 1kHz, 2.5kHz, 10kHz.
15. Media player
Plays your music from USB, SD or BT.
16. Array satellite output
Connect the array satellite with this output.
17. Subwoofer output
Connect passive subwoofer with this output..
18. Fuse
IMPORTANT INFORMATION: Replace the fuse only with a fuse corresponding to the operating voltage. Please
observe the label on the housing. If the fuse blows repeatedly, please contact an authorised service centre
19. Power input
A suitable power cord is included in the delivery.
20. Power switch
On / Off switch for the power supply of the device.
3