Power Dynamics PA300 Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROL PANEL
1. MASTER VOL: This knob controls the master volume.
2. FOLDER: Press this button to enter FOLDER selection (the character in the LCD display will flash). Press again to engage
the selection.
FOLDER ▲: Press this button to advance the folder selection in USB/SD mode.
3.
FOLDER ▼: Press this button to go back within the folder selection in USB/SD mode.
4.
5. MODE (USB/SD/BT): Toggle the audio source between USB port, the SD card slot and BT.
BT PAIR: Press the button for some seconds and search for "PA300" on your BT device. Short press 1 second to turn off
6.
BT and reconnect to the stored paired device. If asked for a pairing code, enter "0000".
7. REPEAT: The REPEAT function allows you to REPEAT one track or the entire track list when in USB/SD/BT mode.
8. DISPLAY: The LCD display indicates track/folder, time, battery level and mode info.
9. PREVIOUS: Press this button to go to the previous track. Press and hold to scan backwards within tracks.
10. PLAY/PAUSE: Press this button to alternate between PLAY- and PAUSE mode.
11. NEXT: Press this button to go to the next track. Press and hold to scan forwards within tracks.
12. MIC 1 AND 2, VOL AND TONE/ECHO CONTROL: This connector can either take a Jack ¼'' balanced or a XLR balanced
cable. With volume you can decrease/increase the microphone volume. The smaller knob is echo control for the
microphone.
13. SD CARD SLOT: Insert an SD card in this slot.
14. USB PORT: Used to connect a USB memory stick and also you can connect your USB charging device (e.g. smart phone,
iPod/iPhone/iPad) to this port for charging (Note : for charging you must be in USB mode). This port is not suited to
Portable hard drives unless the hard drive has its own power source.
15. USB/SD/BT VOL: This knob controls the output level of the USB/SD/BT channel.
16. AUX IN: This stereo RCA input and 3.5mm (stereo) mini jack can be used to connect various audio sources (you cannot
use both inputs simultaneously, doing so may cause damage to the input devices).
17. AUX IN VOL: This knob controls the output level of the AUX input.
4