INVENTOR QLT-550 Manual Del Propietário página 5

|Assembly Instructions
Assembly procedures
1
Take down the air inlet grill
2
Take out the Pre-Filter
Press the U-shaped buckle to pull
outward, and take out the Pre-Filter
3
Take out the HEPA Filter
Hold both sides of the HEPA Filter
with both hands, and take out the
HEPA Filter
4
Remove the protective film of the
HEPA Filter
EN
5
Assemble the HEPA Filter
6
Assemble the Pre-Filter
Align the slot position at the bottom, and
buckle up the upper U-shaped buckle
7
Assemble the air inlet grill
Align the slot position at the bottom, press
both sides of the upper part of the air inlet
grill, and buckle up the air inlet grill
8
Assemble the filter on the other side
Repeat Steps 1-7 to assemble the filter on the
other side, and then power on for operation
5