LEDA301xx-x/302xx-x/303xx-x/305xx-x
2.
Use the mounting bracket [1] to determine the location of the
mounting holes.
3.
Drill the holes and secure the bracket using screws and wall
plugs.
4.
Connect the power cable to a suitable junction box (not incl.).
Make sure the connection is properly earthed. Make sure there is
no strain on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order
to avoid any hazard.
5.
To point the lamp in the desired direction: loosen the hinges [2]
using a spanner.
6.
Tilt the lamp in the desired angle and tighten the hinges.
7.
Cleaning and maintenance
All screws should be tight and free of corrosion.
The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not
be deformed, modified or tampered with; e.g. do not drill extra
holes in mounting supports, do not change the location of the
connections...
Mechanically moving parts must not show any signs of wear and
tear.
The electric power supply cables must not show any damage.
Have a qualified technician maintain the device.
V. 01 – 04/07/2013
N = neutral, blue
E = earth, yellow/green
L = line, brown
6
©Velleman nv