Waeco MagicWatch MWE650 Instrucciones De Montaje Y De Uso página 36

Sistema de ayuda para aparcar

Idiomas disponibles

MWE-650-4DSM.book Seite 36 Dienstag, 16. Mai 2006 4:42 16

Installing MagicWatch

6.1

Tools required

For installation and assembly you require the following tools:

Drill bit set (see fig. 1.1, page 3)

Drill (see fig. 1.2, page 3)

Screwdriver (see fig. 1.3, page 3)

Set of ring or open-ended spanners (see fig. 1.4, page 3)

For making and testing the electrical connection the following tools are

required:

Diode test lamp (see fig. 1.5, page 3) or Voltmeter (see fig. 1.6, page 3)

Crimping tool (see fig. 1.7, page 3)

Insulating tape (see fig. 1.8, page 3)

Cable bushing sleeves, if required

To secure the controller and the cable you may require additional screws

and cable binders.

6.2

Fitting the sensors

The sensors must be correctly aligned for the device to work.

If these point to the ground, bumps in the ground may be inter-

preted as obstacles. If they point too far up, obstacles will not be

detected.

Note the following information during installation:

The maximum range is around 2,5 m for the visual display and 1.5 m for

the audible display.

So that the corners of the vehicle (indicator lights etc.) can be monitored,

the sensor should not be fitted more than 0.3 m away from them.

The distance from the sensors to the ground must be between 40 cm and

50 cm (see fig. 10, page 6).

MagicWatch MWE650