Ryobi P20023 Manual Del Operador página 12

WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
TOOLS NEEDED
See Figure 2.
The following tool (not included or drawn to scale) is needed
for assembly:
 Phillips Screwdriver
ATTACHING THE FRONT HANDLE
See Figure 3.
 Loosen the wing nut and remove bolt from the handle.
 Install the handle on the rear handle pole in the area
indicated by the illustration.
 Adjust handle up or down, if necessary, to desired
operating position.
 Reinstall the bolt and wing nut. Tighten wing nut to secure.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ASSEMBLY
ATTACHING GRASS DEFLECTOR
See Figure 4.
WARNING:
The line cut-off blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
 Remove the battery pack.
 Fit the slot on the grass deflector onto the tab on the
motor housing. It should click into place.
 Line up the screw hole in the grass deflector with the hole
in the motor housing.
 Install supplied screw and tighten by turning clockwise
with a Phillips screwdriver.
OPERATION
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
INSTALLING/REMOVING BATTERY PACK
See Figure 5.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To install:
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
To remove:
 Depress the latches and remove the battery pack.
6 — English