GE JBS86 Manual Del Propietário página 19

Cleaning the Glass Cooktop (Cont.)
Burned-On Residue
NOTE: DAMAGE to your glass surface may occur if you
use scrub pads other than those recommended.
1. Allow the cooktop to cool.
2. Spread a few drops of ceramic cooktop cleaner on
the entire burned residue area.
cooktops, rub the residue area, applying pressure as
needed.
Heavy, Burned-On Residue
1. Allow the cooktop to cool.
a 45° angle against the glass surface and scrape the
soil. It will be necessary to apply pressure to the razor
scraper in order to remove the residue.
3. After scraping with the razor scraper, spread a few drops
of ceramic cooktop cleaner on the entire burned residue
remaining residue.
Metal Marks and Scratches
1. Be careful not to slide pots and pans across your
cooktop. It will leave metal markings on the cooktop
surface.
These marks are removable using the ceramic
cooktop cleaner with a non-scratch cleaning pad for
ceramic cooktops.
Cooktop Seal
To clean the cooktop seal around the edges of the glass,
lay a wet cloth on it for a few minutes, then wipe clean
with nonabrasive cleaners.
Damage from Sugary Spills and Melted Plastic
Special care should be taken when removing hot substances to avoid permanent damage of the glass surface.
removing hot substances.
Be sure to use a new, sharp razor scraper.
Do not use a dull or nicked blade.
1. Turn off all surface units. Remove hot pans.
2. Wearing an oven mitt:
the spill to a cool area on the cooktop.
b. Remove the spill with paper towels.
49-2000903 Rev. 2
4. If any residue remains, repeat the steps listed above
as needed.
5. For additional protection,
after all residue has been
removed, polish the entire
surface with ceramic
cooktop cleaner and a
paper towel.
4. For additional protection, after all residue has been
removed, polish the entire surface with ceramic
cooktop cleaner and a paper towel.
2. If pots with a thin overlay of aluminum or copper
are allowed to boil dry, the overlay may leave black
discoloration on the cooktop.
This should be removed immediately before heating
again or the discoloration may be permanent.
NOTE: Carefully check the bottom of pans for roughness
that would scratch the cooktop.
3. Any remaining spillover should be left until the surface
of the cooktop has cooled.
4. Don't use the surface units again until all of the
residue has been completely removed.
NOTE: If pitting or indentation in the glass surface has
already occurred, the cooktop glass will have to be
replaced. In this case, service will be necessary.
cooktops.
The ceramic cooktop scraper
and all recommended supplies
are available through our Parts
Center. See the Accessories and
Consumer Support sections at the
end of this manual.
NOTE: Do not use a dull or nicked
blade.
19