Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction Manual
Model: PFS16022 - PFS16032 - PFS16042
16 INCH STAND FAN
Description of parts
1 Front Guard
2 Guard Nut and Screw
3 Fan Blade
4 Rear Guard Central Fixing Nut
5 Rear Guard
6 Speed Control Switches
7 Motor Housing
8 Oscillation Control
9 Motor Spindle
10 Blade Retaining Nut
11 Pivot Screw
12 Pole Retaining Screw
13 Adjustable Pole
14 Pole Clamp
15 Lower Base Pole
16 Screw Cover
17 Base Fixing Screws
18 Base
19 Base End Caps
Assembling your 16 Inch Pedestal fan
Take the two base cross segments (18) and push the base end caps (19) into the ends and then
cross them over together.
Remove the four screws from the base and attach the lower base pole (15) to the base using a
screwdriver (not supplied).
Unscrew and remove the pole clamp (14) and slide the screw cover (16) down over the
adjustable and lower base pole (13 & 15) until it is in place over the screws.
Replace the pole clamp (14) and at the same time raise the adjustable pole (13). Attach the fan
assembly on top of the pole and tighten the pole retaining screw (12).
NOTE: the adjustable pole (13) can sometimes slip inside the lower base pole (15) during transit.
Remove the Rear Guard Central Fixing (4) nut. Place the rear guard (5) onto the motor housing (7)
and replace the Rear Guard Central Fixing (4) nut by screwing back on clockwise.
Take the fan blade (3) and slide it onto the motor spindle (9) ensuring that notches on the rear
line up with the splines on the shaft. Screw on the Blade Retaining Nut (10) in an anticlockwise
direction.
Remove the guard nut & screw (2) from the front guard (1).
Turn the five clips around the outside edge of the front guard outwards.
Hang the front guard (1) over the top of the rear guard (5) and push the clips inwards until the
front guard is fastened to the rear guard.
Finally fit the nut and screw (2) through the hole in the bottom edge of the front guard arrowed
and tighten with a screwdriver.
Operating Instructions
Place the fan into the desired position and ensure that it is level.
Press the '0' button to ensure the fan is in the off mode.
The fan can be tilted vertically up and down by moving the guard assembly up and down to the
desired position. NOTE: do not adjust the fan while it is connected to the mains.
Slacken the pole clamp (14) and adjust the fan to the desired height, tighten the pole clamp once
the desired height is set.
Insert the mains plug into the nearest socket, press 1 for low speed, 2 for medium speed or 3 for
high speed. Press the '0' button to switch the fan off.
Publicidad
