CAVOE GRAND PRIX PRO Manual página 8

instaLLation Position
en
car seat's eLements
1. Shoulder strap runner
2. Hip strap runner
3. Leverage of the ISOFIX connectors extension
4. Owner's manual compartment
5. Upholstery
6. Base
7. Height adjustment
8. Backrest shell
9. Folding system button
10. Base
11. ISOFIX connector release button
12. Button releasing additional ISOFIX connector lock
13. ISOFIX connector
14
Proper places to install the
car seat in a car are shown on
the left side:
Forbidden places to install
the car seat
Safe places to install the
car seat
OPERATING INSTRUCTIONS
HEADREST HEIGHT ADJUSTMENT
Pull the leverage at the rear part of the headrest so the shoulder strap runs over child's
shoulder (not the neck) (pic 1.)
CAR SEAT MOUNTING WITH USE OF ISOFIX
Pull forward the releasing ISOFIX connector leverage and set proper height
of the headrest, seat the baby in the car seat and secure it with vehicle's seat belts.
Run the shoulder seat belt through the runner located in the upper part right under the
headrest. The shoulder strap shall run over the child's shoulder. Next, pass the buckle
through hip strap and insert it to the seat buckle (pic. 5). Make sure, that the hip strap
runs above child's thighs, not around its belly.
car seat disassemBLy
In order to remove the car seat from the vehicle, release the ISOFIX connector by
pulling the release button towards direction marked with arrow. At the same time press
and hold the button that releases additional lock (pic. 6). Next pull ISOFIX releasing
leverage and push the connectors inside the car seat's base (pic 7.).
CAR SEAT FOLDING FUNCTION "SPACE SAVE"
The car seat has folding function. It may be used when the car seat is mounted
in the car, and when stored detached car seat. ATTENTION! Do not fold the car seat then
child is sitting in it.
In order to fold the car seat press the folding button located in the rear part of the base
(pic 8.) and push the backrest forward (pic 9.).
In order to unfold the car seat, set the backrest in vertical position (pic 10.). It will lock
automatically.
Backrest tiLt adjustment
To increase the angle between the seat and the backrest hold the ISOFIX connectors
extension leverage and pull the car seat's base forward. Moving the base by one position
forward will result in increasing angle by one position. To reduce the angle push the base
in opposite direction (pic. 11).
en
15