Ryobi PCL705 Manual Del Operador página 4

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper in-
terpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
Recycle Symbol
V Volts
min Minutes
Direct Current
n o
No Load Speed
.../min Per Minute
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NAME
This product uses lithium-ion (Li-ion) batteries. Local, state or federal laws
may prohibit disposal of batteries in ordinary trash. Consult your local waste
authority for information regarding available recycling and/or disposal options.
Voltage
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
ASSEMBLY
OPERATION
SYMBOLS
DESIGNATION/EXPLANATION
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 6.
 Insert the battery pack into the battery port.
 Make sure the latches on each side of the battery pack
snap into place and that the battery pack is secured in
the hand vac before beginning operation.
 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
hand vac.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
4 — English