Tectro R236 Instrucciones De Uso página 87

15
17
19
STEP 17
STEP 18
STEP 19
21
23
STEP 21
STEP 23
25
M
27
STEP 2
15. Slide the wick adjuster assembly down the draft tube.
16
16. Mount 4 wing nuts on the mounting stud, but do not
17. Raise the wick to the full "up" position, and evently
18. Check the wick height. It should be 5/16 inch above the
19. Check for the correct clearance between wick holder
18
20. Check the function of the tip-over safety stop by push-
STEP 16
21. Reinstall the automatic ignition assembly.
22. Reinstall the wind cover.
23. Remove the knurled wick adjustment knob once again,
20
24. Reinstall the cabinet .
25. Tighten the 5 screws on the cabinet .
26. Reinstall the combustion chamber 4 and the fuel tank
27. Reinstall the knurled wick adjustment knob 2. Close
22
STEP 20 STEP 20
Install the batteries in the battery case and fill the fuel tank
with Qlima Premium Quality Fuels. Put the tank into the
heater and wait at least 30 minutes for the new wick to fully
saturate with the fuel.
24
STEP 22
H
STEP 3
26
Position the adjuster shaft to the front of the heater.
tighten.
tighten wing nuts in several steps.
collar.
and draft tube. It should be the same all around.
ing the extinguish button  to activate the pendulum.
if it was reinstalled before K.
.
the front plate.
4
87