Black and Decker PRO CS2001 Manual De Instrucciones página 22

22 • ENGLISH
LUBRICATION
Black & Decker power tools are properly lubricated at the
factory and are ready for use. Tools should be
re-lubricated regularly , depending on usage. This
lubrication should only be attempted by trained power tool
repair persons, such as those at Black & Decker service
centers or by other qualified service personnel.
Closed-type, grease-sealed ball bearings are used
throughout. These bearings have sufficient lubrication
packed in them at the factory to last the life of the chop
saw.
CLEANING
Warning! unplug the tool before you use a cloth to
clean the housing.With the motor running, blow dirt and
dust out of all air vents with dry air at least once a week.
Wear safety glasses when performing this. Exterior plastic
parts may be cleaned with a damp cloth and mild
detergent. Although these parts are highly solvent
resistant, NEVER use solvents.
Blowing dust and grit out of the main housing by means of
an air hose is recommended and may be done as often as
dirt is seen collecting in and around the air vents. Always
wear proper eye and respiratory protection.
TOOL CARE
Avoid overloading the machine.Overloading will result in a
considerable reduction in speed and efficiency and the
unit will become hot. In this event,run the machine at no
load for a minute or two until cooled to normal working
temperature by the built in fan. Switching your machine on
and off whilst under load will considerably reduce the life of
the switch.
IMPORTANT
To ensure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment (other than those listed in
this manual) should be performed by authorized service
centers or other qualified organizations, always-using
identical replacement parts. Unit contains no user
serviceable parts inside. Blowing dust and grit out of the
main housing by means of an air hose is recommended
and may be done as often as dirt is seen collecting in and
around the air vents.
Always wear proper eye and respiratory protection.
Note: Unit may be converted to a 3-wire twist lock cord set
at an authorized service center.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
household waste. Make this product available for separate
collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials. Local regulations may
provide for separate collection of electrical
products from the household, at municipal waste
sites or by the retailer when you purchase a new
product.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned
and authorized service locations. All Black & Decker
Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool
service. For more information about our authorized
service centers and if you need technical advice, repair,
or genuine factory replacement parts, contact the Black
& Decker location nearest you, or visit us at www.
BlackandDecker-la.com
SPECIFICATIONS
Voltage
AR
B2C
B3
B2
BR
Power
Speed
Max. Diameter
CS2001
220V ~ 50Hz
220V ~ 50Hz
120V ~ 60Hz
220V ~ 60Hz
127V ~ 60Hz
2100W
3800 rpm
355mm