Makita XDT03 Manual De Instrucciones página 34

Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after switch trigger
release, have tool serviced at a Makita service center.
Lighting up the lamp
2
1
015163
To turn on the lamp, slightly pull the switch trigger,
release it and then press the button for a few seconds.
The lamp turns on. The lamp goes out approximately 10
seconds after releasing the switch trigger. To turn on the
lamp again, slightly pull the switch trigger again.
To keep turning off the light, slightly pull the switch
trigger and release it. Then press the button a few
seconds.
In push drive mode with the switch trigger locked, the
lamp goes out approximately one minute after the motor
stops.
NOTE:
While pulling the switch trigger, the lamp mode
•
cannot be changed.
For approximately 10 seconds after releasing the
•
switch trigger, the lamp mode can be changed.
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
1. Lamp
2. Button
6
Indicating remaining battery capacity
015174
When you pull the switch trigger, the battery indicator
shows the remaining battery capacity.
The remaining battery capacity is shown as the
following table.
Battery indicator status
Blinking
On Off
015175
NOTE:
Approximately one minute after the motor stops,
•
the indicators go off to save the battery power. To
check the remaining battery capacity, slightly pull
the switch trigger.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to the
motor to extend tool and battery life.
The tool will automatically stop during operation if the
tool or battery are placed under one of the following
conditions. In some conditions, the indicator lights up.
Overload protection
When the tool is operated in a manner that causes it to
draw an abnormally high current, the tool automatically
stops without any indications. In this situation, turn the
tool off and stop the application that caused the tool to
become overloaded. Then turn the tool on to restart.
1. Battery indicator
1
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery