Troubleshooting - AEG LAVAMAT 61270 WDBI Manual De Instrucciones

TROUBLESHOOTING

Certain problems are due to lack of sim-
ple maintenance or oversights, which can
be solved easily without calling out an en-
gineer. Before contacting your local Serv-
ice Centre, please carry out the checks lis-
ted below.
During machine operation it is possible
that the yellow pilot light of button 8
blinks, one of the following alarm codes
appears on the display and at the same
time some acoustic signals sound every
20 seconds to indicate that the machine is
not working:
Problem
The washing machine
does not start:
The machine does not
fill:
The machine fills then
empties immediately:
•
•
•
•
ted
Once the problem has been eliminated,
press the button 8 to restart the pro-
gramme. If after all checks, the problem
persists, contact your local Service Centre.
Possible cause/Solution
The door has not been closed.
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme dial is not correctly positioned and
the button 8 has not been pressed.
• Please turn the programme dial and press the but-
ton 8 again.
The delay start has been set.
• If the laundry is to be washed immediately, cancel
the delay start.
The Child safety lock has been activated.
• Deactivate this device.
The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are
blocked.
• Clean the water inlet filters. (See "Cleaning the wa-
ter inlet filters" for more details)
The door is not properly closed.
• Close the door firmly.
The end of the drain hose is too low.
• Refer to relevant paragraph in «Water drainage»
section.
: problem with the water supply
: problem with the water draining
: door open
: anti-flooding system has activa-
ENGLISH
27