Danby Products DAC180EB3WDB Manual Del Propietário página 19

OPERATING INSTRUCTIONS
FOLLOW ME FUNCTION
There is a temperature sensor built into the remote
control that will continuously collect the current
room temperature. Keep the remote control with
you and the appliance will automatically adjust the
set temperature based on the current temperature
where you are located to reach the most
comfortable condition and temperature.
Press the Follow Me button to activate the Follow
Me function. The remote will display the current
temperature at its location. The remote will send
a signal to the air conditioner every 3 minutes, so
long as you remain within range of the appliance.
The Follow Me light on the control panel of the
appliance will illuminate for 5 seconds every three
minutes to indicate that it has received a signal
from the remote. If the appliance does not receive a
signal from the remote during any 7 minute interval,
it will beep to indicate that the Follow Me mode has
ended.
The maximum distance for the Follow Me feature is
8 meters (26 feet). This feature is available in Cool
and Auto modes.
SLEEP FUNCTION
The Sleep Function can be used to conserve energy
during sleeping hours.
When selected, the set temperature will increase
by 1°C/2°F every half hour for one full hour. The
appliance will hold the new set temperature for
6 hours before automatically returning to normal
operation.
The Sleep Function can be canceled at any time by
pressing the Sleep Button.
ENERGY SAVER FUNCTION
The Energy Saver Function will automatically cycle
the fan on and off when the compressor is not in
use to minimize how often the compressor needs to
turn on. This function is available in Cool, Dry, Auto
Cool and Auto Fan modes.
The fan will continue to run for 3 minutes after the
compressor turns off. The fan will then cycle on for
2 minutes in 10 minute intervals until the ambient
temperature is above the set temperature, at which
point the compressor will turn on and cooling will
resume.
ADJUSTING AIR FLOW
The louvers on the front of the appliance can be
adjusted up and down or left and right to direct air
fl ow throughout the room as required.
Note: When in cooling mode, ensure the louvers
are pointed upward. If the appliance operates in
cooling mode with the louvers pointed downward
for an extended period of time, condensation can
form on the louver and drip from the surface of the
blades.
18