Descargar Imprimir esta página

DENIA C-700 Instrucciones De Utilización Y De Mantenimiento página 7

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Since this device has been tested in a homologated laboratory and since we check our
devices a full 100%, making sure that the electric wiring operates correctly before shipping,
the fan and the electric wiring are not covered by our warranty.
PROPERTIES OF THE FAN
This model is equipped with a tangential fan (170 m3/h). It takes the air in the lower
part to circulate in the woodstove and share it out from the top part.
The fan has a thermostat to regulate the temperature. It starts to 50ºC to prevent overheating
The woodstove has an electric switch with three positions to regulate the hot air flow rate.
- In position 0, the fan is off but if the temperature reach 50ºC, the thermostat let
the fan starting, on the position I
- In position I, the fan reach 60% of the maximum speed.
- In position II, the fan reach the maximum speed.
IMPORTANT: The fan must be ALWAYS connected to the network to prevent overheat to
deterioration
FUEL
- Use only dry wood with a maximum moisture content of 20%. Wood with a moisture
content higher than 50 or 60% does not heat and combusts very badly, and creates
a lot of tar, releases excessive amounts of vapour and deposits excess sediments onto
the device, glass and smoke outlet.
- The fire should be lit using special fire lighters, or paper and small pieces of wood.
Never try to light the fire using alcohol or similar products.
- Do not burn domestic rubbish, plastic materials or greasy products that can pollute
the environment and lead to risks of fire due to obstruction of the pipes.
7
Mod.
C - 7 0 0

Publicidad

loading