Publicidad
Idiomas disponibles
Idiomas disponibles
DMX SETTING
14 Channels
Channel
Function
1
X
2
Y
3
X-16Bit
4
Y-16Bit
5
Dimming
6
Red
7
Green
8
Blue
9
Strobe
10
Color Mix
Stand-Alone/
Sound-Active
11
Stand-Alone colour
12
speed
13
X，Y Speed
Reset
14
DMX-512 CONNECTION
If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the
DMX input of the first unit in a DMX chain. If you wish to connect a DMX controller with other XLR outputs
you will need to use adapter cables.
Connect the DMX output of the first unit in a DMX chain with the DMX
input of the next unit in the chain. Always connect the output of one unit
with the input of the next unit until all units are connected. If you use a
controller with 5 pin DMX connection you will need to use a 5 pin to 3 pin
adapter.
Caution at the unit, the DMX cable has to be terminated with a terminator. Solder a 120 Ohm resistor
between signal (-) and signal (+) into a 3-pin XLR connector and plug this into the DMX output of the
last unit in the chain.
DMX MODE
This mode allows you to use universal DMX-512 console to operate.
1. Install the units in a suitable position.
2. Use standard XLR cable to connect your units together via the XLR connector on the rear of the
units. For longer cable we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit using the display or dipswitches.
4. Turn on all units. Use DMX console to control your units.
Value
Description
000-255
0-540°
000-255
0-255°
000-255
000-255
000-255
From dark to bright
000-255
From dark to bright
000-255
From dark to bright
000-255
From dark to bright
000-255
From slow to fast
000-255
002-060
Gradually
061-120
Jump
121-180
Gradually+jump
181-240
Sound-active+flash
241-255
Sound-active+ jump
000-255
From fast to slow
000-255
From fast to slow
000-250
No function
251-255
Reset after 2 second intervals
Publicidad
