Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
2. Install: Press in on the two Latches
located on either side of the Dust Drum
until they snap into place, securing the
Powerhead Assembly to the Dust Drum.
3. Remove: Pull out on the two Latches
and lift Powerhead Assembly from the
Dust Drum. Do not force the Latches to
rotate more than slightly outside Drum
flange.
Powerhead
Assembly
Latches
(2)
Vac Inlet
Locking Accessories
1. To Connect Accessory:
Your RIDGID Wet/Dry Vac includes
Locking Accessories to prevent the
Accessories from falling off when in
use. To connect the Accessories, align
the Nozzle Ridges of the Accessory with
the Release Button of your Extension
Wand. Press to secure the Nozzle to
the Extension Wand.
CONNECT:
Accessory Nozzle
Ridges
2. To Disconnect Accessory:
Twist the Nozzle and Extension Wand
to disengage the Nozzle Ridges and
pull. You may also press the Release
Button and pull to disengage.
DISCONNECT:
Accessory Nozzle
Ridges
7
Extension Wand
Release Button
Extension Wand
Release Button
Publicidad
