Nobilia F89 TSL3 Montaje Y Modo De Empleo página 20

TSL3
General notes: Any function can be activated by pressing softly the button under
F
the symbol.
A. ON/OFF light button: By essing this button the hood's lights switch on.
E
B. ON/OFF motor button: By pressing this button the extracting motor can be
activated/stopped.
D
C.D.E.F. Speed regulator button: By progressing this button the hood activates the
selected extracting speed.
Funzione Timer: By pressing once again the Selectedspeed button,the timer will
C
last for 5 minutes. This is possible for each of the 3 or 4 speed (depending on
model). After 5 minutes the hood will automatically turn off.
Grease filter saturation: After every 40 hours of use of the hood, the button B or E+F
indicator shows byflashing slowly that the grease filters need to be washed.
B
Charcoal filter saturation: After every 120 hours of use of the hood, the button B or
E+F indicator by flasihing fast shows
A
that the charcoal filters need to be replaced.
Note: By pressing for at least 5 minutes the button E+F will reset the filters
saturation indicator.
Attention! This function should only be used afterperforming the maintenance of
the filters.
Automatic functioning through the heath sensor:
By pressing the button C D at the same time, the hood starts the automatic
functioning. The indicators of the 4 speeds will flash in sequence . After more or
less 30 seconds the temperature sensor will start the motor choosing the right
extracting speed.The speed will change according to the heath coming from the
hob. By pressing B the manual functioning can be restored.
Always clean the glass of the control for a correct functioning.
All hoods with capacities exceeding 650 m3/h have the last timed speed; It lasts for
7 minutes, after which it automatically returns to the last non-timed speed.
OPERATION
20
GB