Descargar Imprimir esta página

Toolland TM82000 Manual Del Usuario página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
Keep this manual for future reference.
4.
Features
ergonomic soft grip
rotating handle
LED work light and built-in flash light
LED power indicator
spindle-lock function
included: ● 49x 25 mm bits ● 1x 60 mm magnetic bit holder ● 1x charger ● 1x gift box
5.
Overview
Refer to the illustrations on page 2 of this manual.
1
keyless chuck
2
torque setting
3
work LED
4
battery level
5
handle locking button
6.
Charging the Battery
Do not puncture batteries or throw them in fire as they may explode. Do not
attempt to recharge non-rechargeable batteries (alkaline). Dispose of batteries in
accordance with local regulations. Keep batteries away from children.
Place the device and charger on a flat, non-flammable surface and away from
1. Connect the device to the charger.
2. Insert the plug of the charger into the mains.
3. Check the charging status of the device:
Red LED: The battery pack is insufficiently charged. Please recharge.
Yellow and red LED: The battery has an adequate remaining charge.
All LEDs: The battery is fully charged.
4. Disconnect from the charger and insert in the device. Disconnect the charger from the mains.
7.
Using Your Drill
Before using the device, inspect it to ensure there is no excessive wear. Never use a
1. Make sure the battery is sufficiently charged.
2. Place the direction switch to the middle position in order to lock the power trigger.
3. Press the chuck ring towards the device and insert an appropriate bit. Release the chuck.
4. Place the direction switch at the desired position. Press the power trigger to use the drill.
5. Adjust the torque if needed.
6. The handle can also be adjusted. To do so, press and hold the handle locking button while turning the
handle. Lock the handle by releasing the handle locking button.
V. 01 – 15/07/2016
TM82000
WARNING
WARNING
flammable material during charging.
WARNING
damaged drill bit.
5
6
direction switch
7
power trigger
8
work light switch
9
power input
©Velleman nv

Publicidad

loading