Publicidad
Idiomas disponibles
Idiomas disponibles
· Avoid overfilling the fuel tank.
· After refueling, tighten the fuel cap securely.
NOTE: If any gasoline was spilled, make sure the
area is dry before starting the engine.
BEFORE THE OPERATION
The pump chamber should be completely filled
before operating. Never attempt to operate the
pump without priming water or the pump will
overheat. Extended dry operation will destroy
the pump seal.
If the unit has been operated dry, stop the en-
gine immediately and allow the pump to cool
before adding priming water.
IMPORTANT: Fill the pump chamber when
the engine it's cooled and in no operation.
STARTING THE ENGINE
1. OPEN the fuel valve.
2. CLOSE the choke lever.
3. Turn the engine switch to the ON position.
4. Slightly accelerate the throttle lever.
5. Pull the starter grip lightly until resistance is
felt, then pull it briskly until starts.
1
OPEN THE
GASOLINE
VALVE
3
PLACE THE
IGNITION
SWITCH ON
"ON"
IMPORTANT: Do not allow the starter grip to
snap back against the engine. Return it gently
to prevent damage to the starter.
10
WATER PUMP SET-UP
The following image shows the correct water
pump set up and relation between the water
level with the suction and discharge action.
The suction from the water surface through the
water pump and maximum pump lift is known
as "Total discharge".
For an optimum performance place the water
pump as near as possible of the water source
(river, cistern etc.) this results in a faster dis-
charge with less priming time.
NOTE: Discharge capacity is always larger than
suction capacity.
2
OPERATION
CLOSE
1. As the machine warms
CHOKE
up, open the choke.
2. Set the speed at full
throttle.
STOPPING THE ENGINE
1. Turn the engine switch to the OFF position.
2. As a recommendation CLOSE the fuel valve
when the engine stops.
MAINTENANCE
forming any maintenance. If the engine must be
run, make sure the area is well ventilated.
4
"ACCELERATE"
A LITTLE
CHANGING THE OIL
NOTE: It's recommended to change the oil after
the first month or after 20 hours of use. After
this, every 6 months or 100 h of use.
• Drain the oil while the engine is still warm to
assure rapid and complete draining.
1. Remove the oil filler cap and the drain plug
to drain the oil.
IMPORTANT: Shut off the engine before per-
Water surface
1
2
Publicidad
