Greencut GE210XE Manual De Instrucciones página 60

60
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies.
PROBLEM
• Fuel tank is empty
• Clogged fuel filter
The engine
• Spark plug wire disconnected
fails to start
• Defective spark plug
• Defective spark plug
• Loose spark plug wire
• The unit continues to operate with the
choke
Power loss;
• Fuel line clogged
Irregular
• The fuel tank is almost empty
operation
• Carburettor requires a reset
• Dirty/clogged air filter
• Fuel tank dirty
The motor
• Low level of engine oil
overheats
• Debris around the engine
• Loose motor support plate
The unit • Damaged blades
vibrates
• Debris stuck on the blades
• Uneven surface
The unit does
• The shredder is blocked
not discharge
The unit does
• The unit takes longer to process the
not work material
NOTE: In the event of not being able to resolve the problem, get in touch with an Official Technical
Service.
POSSIBLE CAUSE SOLUTION
• Fill the fuel tank with the correct fuel
• Clean the fuel tank
• Connect the wire to the spark plug
• Clean the spark plug
• Replace the spark plug
• Tighten the spark plug connection
• Move choke lever to normal state
• Clean the fuel lines
• Fill the fuel tank
• Consult your local distributor
• Clean or replace the air filter
• Clean the fuel tank
• Fill with the correct level of oil
• Turn off the unit and clean around the
motor
• Tighten the support plate
• Check the blades and replace them if
necessary
• Check the blades and remove any debris
• Place the unit on a flat surface
• Disconnect the spark plug wire and then
clean the shredder
• Add dry material or a mixture of different
materials
• Reduce the volume of material in the
conduit
• Check that the blades are not broken
• Check and replace the blades
• Replace or sharpen the blades
• Check that the belt is properly tensed